4 Important Steps to Install Rubber Roof Flashings in Your House

Flashings are a vital aspect of roof. They tend to direct the flow of water at the openings. The flashings protect your house from structural damage or mold infestations that might occur when water seeps into your house and comes in contact with different structural elements. This is the reason why installing rubber roof flashing in an appropriate manner is extremely important, especially when you are building a new home or modifying the exteriors.

Rubber Roof Flashings

Rubber Roof Flashings

Now, if you have decided to replace the flashing of your house then there are 4 easy steps that you need to follow. However, while working on roof do ensure that you follow required precautionary steps, so as to install the flashing in a safe and secured manner. Make sure that you have roof ladder or scaffolding for the job, along with other tools. One thing that should be noted is that never ever places the tools on the skylight of the roof and don’t even walk on them too.

Step 1: Removing Old Rubber Roof Flashings

If your old flashings are in a terrible condition then you need to remove them from your roof. For doing this you need to start by chipping off the mortar and work along the edges. A high quality masonry chalk can be used for sealing the joints that prevails in-between chimney and flashing. If you are removing flashing from the valley of the roof then start by lifting the edges that are surrounded by shingles and then easily make your way towards the end of the roof.

Roof Flashings

Roof Flashings

Step 2: Preparing the New Rubber Roof Flashings

Once you have removed the old flashings from the roof, the next step is to work on the new rubber roof flashings. For doing this there are three processes that you should follow and they are:

Cutting: The first thing that you need to do is to cut the flashings as per the specified measurements. If you are unaware about the exact value then it is always advisable to measure the dimensions of the roof where you want to install the flashings and then cut the new flashings according to your requirements. Make sure that you have precise measurements, because even minute alternations can cause improper installation of flashings.




Gluing: This process is usually carried out in two phases; in phase one, water based adhesives are applied on the deck of the roof with the help of a roller that would prevent any sort of lumps or cracks. Next a contact adhesive is used at the corners of the roof that will allow the flashings to stick to the roof in a hassle free manner.

Russ Strip: It is often seen that rubber flashings tend to shrink with time. Therefore to avoid this, the Russ strip is used. This strip will not only reduce the chances of shrinkage but at the same time ensure that the flashings remain at its best condition.

Rubber Flat Roofing

Rubber Flat Roofing

Step 3: Applying Roof Trims

Selecting the high quality roof trims is essential, metal are perhaps one of the most prominent forms of roof trims that are available along with metal gutter edges. They are regarded to be affordable options that are best for placing your rubber roof flashings at the stipulated location.

Step 4: Fitting the Roof Flashings

The last step is to place the roof flashings on the roof. This step is performed with the help of a plastic coated metal strip even known as wall trim. These strips allow you to place the flashings on the roof in an effective manner with perfect accuracy.